Moffat MGH701X Manual de usuario descargar pdf (Pagina 8)

Lighting the burnersLighting the burners

Lighting the burners

For easier lighting, proceed beforeFor easier lighting, proceed before

For easier lighting, proceed before

putting a pan on the pan support.putting a pan on the pan support.

putting a pan on the pan support.

To light a burner:

z turn the relevant knob anti-clockwise to

maximum position (

), then push it down

to ignite the burner.

z Check the flame is regular and adjust it as

required.

z To put the flame out, turn the knob to the

symbol

If the burner does not ignite, turn the control

knob to zero, and try again.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. - lett.

A) and

the"crown" (Fig. - lett.

B) are in the correct

position.

Operation

)

Do not keep the control knob pressedDo not keep the control knob pressed

Do not keep the control knob pressed

for more than 15 seconds. If the burnerfor more than 15 seconds. If the burner

for more than 15 seconds. If the burner

does not light even after 15 seconds,does not light even after 15 seconds,

does not light even after 15 seconds,

release the control knob, turn it therelease the control knob, turn it the

release the control knob, turn it the

“off” position and wait for at least one“off” position and wait for at least one

“off” position and wait for at least one

minute before trying to light the burner again.minute before trying to light the burner again.

minute before trying to light the burner again.

If the burner accidentally goes out, turn the control knob to theIf the burner accidentally goes out, turn the control knob to the

If the burner accidentally goes out, turn the control knob to the

“off” position and wait for at least 1 minute before trying to light“off” position and wait for at least 1 minute before trying to light

“off” position and wait for at least 1 minute before trying to light

the burner again.the burner again.

the burner again.

When switching on the mains, after installation or a power cut, it is quite

normal for the spark generator to be activated automatically.

In the absence of electricityIn the absence of electricity

In the absence of electricity, ignition can occur without the electrical

device; in this case, approach the burner with a flame, push the relevant

knob down and turn it anti-clockwise until it reaches the maximum position.

If the control knobs become difficult to turn, please contact your local

Service Force Centre.

A - Burner cap

B - Burner crown

C - Ignition electrode

Triple crown burner

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comentarios a estos manuales

Sin comentarios

Moffat MGH701X Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Moffat MGH701X