Moffat MCP650BK Manual de usuario descargar pdf (Pagina 15)

With regard to the protection against overheating

of surrounding furniture surfaces this appliance

corresponds to type Y. This appliance or the built--

in cupboard for the appliance respectively may be

located with the rear wall and one side wall to wha-

tever high walls or furniture respectively and with

the other side to another appliance or furniture of

the same height as this appliance.

Hob installation

D Cut out the worktop with the cut--out size as sta-

ted. The toleranced sizes must not be exceeded..

Saw exactly at the marking line. Recommenda-

tion: Mark the cut--out with a steel needle.Cover--

glue the line in order to avoid splintering of the

coating when cutting.

D With tiled worktops the grooves within the contact

area of the cooking area must completely be filled

up with groove material.

D Clean the worktop in the cut--out section

D From the top lay the cooking area into the cutou-

tand adjust concentrically.

D 4 holes in the bottom of the build--in case are pro-

vided for the screws of the fitting plates.

D At first screw on the fitting plates by a screwdriver

and afterwards regularly tighten the plates alter-

natively and diagonally offset, until the frame of

the cooking area is perfectly laying on the work-

top.

D A too strong and one--sided tightening is to be

avoided! Electric screwdrivers or pusher air-

screws to be exclusively used with slip clutch (set-

ting value 1 -- 1.1 Nm).4

D Check the seal in the supporting frame for perfect

seating and gapless support. Please do not apply

further silicone sealing matter as this will compli-

cate the removal of the hob if servicing is neces-

sary.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Moffat MCP650BK Manual de usuario Pagina 15